 |
We have determined that your material is
as thick as grease.
This is not as difficult as you imagine, but there are some
things of which you need to be aware.
If the material is a single
component, unfilled material with this viscosity, you can use one of many
combinations of valves and reservoirs or syringes and shot meters.
How much will
you need to dispense and how fast? Those questions will help you to decide
which way to go.
|
|
In this category;
Dispense Finder
Single Component
Watery
Slightly Thick
Honey
Sour Cream
Grease
Also of interest;
Dispense Finder
Dispensing Help
Doming & Potting
Solder Dispensing
Other Valves
You may also be
interested in:
Dispensers
Valve Controller
Dispense Valves
Reservoirs
Robot
Platform
Also of interest;
Precision Needles
Needle Nozzles
Thin Wall tips
|
|
If you are dispensing a
filled material, you can still choose from many of the pneumatic dispensers. If you need to make dots
and you want to use a syringe based system, meaning that you are able to put
enough fluid into the syringe to last for a long time, and if you want to
dispense small amounts, from this size ( · ) to this
size ( ● ), you can easily use any of our syringe based systems - or
Shot Meters - unless you plan on shooting thousands
an hour. In that case, see below for valves and reservoirs.
Choose from any of the pneumatic dispensers.
Getting the right
valve.
There are many types of
valves, and we suggest you pay close attention to the descriptions on each
page. It will note that one is better for unfilled
materials while one is better for filled. If you
are not sure of the valve for your specific application, or if you
want us to quote on a specially made valve, send us the
MSDS sheets for your material by
clicking here and filling in the work sheet that best describes the
material you are using. Don't forget the valve controller that will be listed on the
valve page and the valve stand, if you need
one!
If the material is going to be
dispensed in bulk, from 5 gallon pails up to 55 gallon
drum or pail dispensing. This thickness material will most likely require a strong
pump, a ram pump and a follower plate to move the material up to the dispense
valve.
|
