Valve Controller for the complete line of IntelliSpense™ valves and spray valves, including the Micro-Mini Valve, Front Closing Valve, AMD Diaphragm Valve and Pinch Tube valves. For a typical valve setup, click here. Click on picture for close-up.

To feed any IDS valve, choose from our dispensing syringes, (to feed thin to medium materials in very small shots) our single cartridges, (for medium to thicker materials in smaller shots or beads) or for large volume capacity, order one of our reservoirs (for thin to medium materials) or one of our pail dispenser units, for thicker materials. Includes a DB9 Connector that can give feedback to a robot or PLC.

Simple to operate. After filling your choice of reservoir with material and hooking it up to your shop air or compressor, adjust the air pressure into the chamber, cartridge or syringe to your valve (with a low setting at first) then gradually increase the pressure during the setup.

Set the controller switch to manual or automatic, and check all of your connections, activate the air pressure into the chamber, syringe or cartridge by pressing the foot pedal or sending an on signal to the controller from your robot or PLC, while adjusting the flow of material slowly upward until you reach the flow desired. If you are doing a by-eye deposit or running the controller by an external signal, leave the controller in manual mode.

If deposits are made by an operator or in a hand-held or semi robotic application (where all of the shots are identical in volume) switch to Automatic Mode and use the parameters you set, to automatically repeat. The valve controller is a digital shot timer developed for bench top dispensing applications. This controller uses an internal 2-position 3-way solenoid valve to operate a dispense or spray valve.

Features

• Economic and ergonomic operation for easy and safe manual processes.

• Dispenses a wide range of adhesives, coatings, epoxies, and silicones.

• Digital push button timer with 0.01 - 99.99 second time range.

• Manual or timed shot modes.

• Integrated pressure control.

• Electric foot pedal and power cord.

• Built-in regulator and gauge.

• Sample syringes, needles and tips.

Specifications

• Timer: 0.01 sec - 99.99 sec

• Cycle Initiation: Maintained or momentary

• Repeat Accuracy: 0.5 ms (0.0005 sec)

• Recycle Time: 12 ms (0.012 sec)

• Time Setting Accuracy: +/- 2%

• Dimensions: (8.50 in x 6.50 in x 3.62 in)

• Weight: 8 lbs

• Power: 115/230 VAC

• Internal Voltage: 24 VDC

• Air Input: 35-100 PSI • (2.5 - 6.9 bar)

• Air Output: 1-100 PSI • (0.1 - 6.9 bar)

• Certification: CE certified