|
To feed any IDS valve, choose from our
dispensing syringes, (to feed thin to medium materials in very small
shots) our single cartridges,
(for medium to thicker materials in smaller shots or beads) or for large
volume capacity, order one of our
reservoirs (for thin to medium
materials) or one of our
pail
dispenser units, for thicker materials.
Ideal for
thin materials, such as
Cyanoacrylates and other low to medium
viscosity fluids utilizing a
unique floating diaphragm design. This dispensing process utilizes only
one moving part and requires minimal maintenance. Fluctuating air
pressure from the
controller
and material pressure above and below the
diaphragm cause the disk to float up and down to
start and stop the dispense cycle. The wetted part is the
easy to replace diaphragm which allows material to pass through without
touching the metal chamber.
Features
-
Ergonomic wand construction.
-
Safe handheld
dispensing.
-
Delrin® material body.
-
Patented silicone disk with Teflon® film embedded
on
the wetted side.
Specifications
-
Weight: 3.7 oz
-
Viscosity Range: 1 cps - 5,000 cps
-
Operating Air Pressure: 60 - 100 PSI
-
Maximum Fluid Pressure: 60 PSI
-
Wetted Parts: Teflon®, Delrin®
-
Dimensions: 141.63 mm x 44.45 mm
-
Diameter: (5.576 in X 1.75 in
Diameter)
-
Air Source:
IntelliSpense Valve
Controller
Part #
Manual Diaphragm Valves and Kits
ONLY
7010000 AMD
Handheld
Valve - air actuated
7010000SS AMD
Air
actuated Valve SS Luer Adapter
7010000SP Kit
for AMD Handheld Valve - air actuated
7010000SS-SP Kit
for AMD Air actuated Valve - SS Luer
For an AMD
System Package, order by the following number:
7020010 Consists of one AMD
Manually held, Automatically Timed Valve, one
1 lb. Pressure Pot,
(black anodized aluminum body),
one
Valve Controller, and all
necessary regulators, gauges, hoses, fittings, etc.
7020011 Consists of one AMD
Manually held, Automatically Timed Valve, one
1 Gallon Pressure Pot, one
Valve Controller, and all necessary
regulators, gauges, hoses, fittings, etc.
7020012 Consists of one AMD
Manually held, Automatically Timed Valve, one
1 Liter Pressure Pot,
(black anodized aluminum body),
one
Valve Controller, and all necessary
regulators, gauges, hoses, fittings, etc.
ALSO available in a manual, held hand
version:
The
MOD valves are used primarily for operator
controlled, by-eye deposits of many types of fluids, including UV
cure, anaerobic, micro shots of thin fluids, alcohol, acid, electrolyte,
reagent dispensing, anaerobic dispensing, Cyanoacrylate dispensing, solvent
dispensing and more.
For full automation CA
applications,
or when mounted and used in a
valve stand or robotic workstation,
click here.
|
|
